![]() However, it may not be necessary in all cases. In the case that your board does not power on fully without a battery attached, it is OK to attach the battery before following the steps below. If you need one, I prefer the CP2102 as it is cheap and the driver is readily available.You’ll only need this connection to the CC3D, do not plug in the normal USB connection.Unfortunatly the main port cannot be used in the current configuration due to the inverter on this port. Ensure MSP is enabled on the flex port.Simply plug in the board via USB cable.įor the CC3D, connect a USB to UART adapter to the flex port. Wiringįor the NAZE, no external wiring is necessary. This is the option you need to select for the bootloader:Ĭurrently supported on the SPRACINGF3, STM32F3DISCOVERY, NAZE32 (including clones such as the FLIP32) and CC3D. If your ESCs didn’t come with BlHeli Bootloader, you’ll need to flash them with an ArduinoISP programmer first. ![]() 1-wire passthrough esc programming ESCs must have the BlHeli Bootloader.
0 Comments
Leave a Reply. |